ReaFIR automation question

[babag]

i use reafir for noise removal sometimes. i think it's ctl+shift that allows me to use my mouse to raise or lower the graphic display, thus raising or lowering the effect. i didn't see a corresponding automation curve for this action, though. is there a way to automate what i'm describing?

thanks,
BabaG

[Xenakios]

ReaFIR has only very limited automation capabilities.

[vdubreeze]

Automating the dry/wet may be close enough.

[babag]

thanks. dry/wet is not enough in the case at hand, though.

thanks again,
BabaG

[James HE]

Originally Posted by babag

i use reafir for noise removal sometimes. i think it's ctl+shift that allows me to use my mouse to raise or lower the graphic display, thus raising or lowering the effect. i didn't see a corresponding automation curve for this action, though. is there a way to automate what i'm describing?

thanks,
BabaG

sounds like you could possibly get away with using a gain plug to raise / lower the input gain going into ReaFIR - then using another gain plug post ReaFIR to make the opposite gain changes.

[b_blespo]

Originally Posted by vdubreeze

Automating the dry/wet may be close enough.

vdubreeze

i was thinking the same thing as the original poster (except ctrl/drag) but your suggestion was great and worked well for me.

thanks
brian