Imaginado VSTi "DRC" strange behaviour saving settings in Reaper
Anyone use the VSTi "DRC" from Imaginando? I sent the following message to Imaginando just over a week ago and have just resent it after having had no reply back:-
Hi there. I purchased DRC in April and am currently using version 1.1.4. "License Status:Activated" under PROFILE in DRC. Currently using Reaper v5.40 (latest version) with Windows 10 Home 64bit Version 1511. Have not updated Windows 10 since September 2016 and my PC works fine with no problems. Will not be updating it for a while.
1)Load DRC into Reaper.
2)DRC patch is "Default". Edit the "Default" DRC patch.
3)Close the DRC GUI.
4)Save Reaper project and then close Reaper.
4)Open the saved Reaper project.
5)Play back the project - all OK.
6)Open the DRC GUI - DRC settings reset back to the original "Default" patch.
OR
1)Load DRC into Reaper.
2)DRC patch is "Default". Edit the "Default" DRC patch.
3)Leave the DRC GUI open.
4)Save Reaper project and then close Reaper.
4)Open the saved Reaper project. The DRC GUI shows the edited patch correctly.
5)Play back the project - all OK.
6)Close then reopen the DRC GUI - DRC settings reset back to the original "Default" patch.
I have also tried the above but, instead of editing from the "Default" patch, I loaded the "Oddities" patch and then edited the "Oddities" patch. DRC settings reset back to the original "Oddities" patch upon reloading the saved Reaper project.
Version 1.1.4 is the only version, as far as I can remember, that I have used within a project that I have saved and reloaded. I don't have any earlier DRC versions to test.
UPDATE:- tried latest version 1.1.6 but still the same problem. Imaginando have contacted me and are looking into it.
Last edited by hesnotthemessiah; 06-19-2017 at 04:37 AM.
Reason: Update
|