Automation segment bug (FIXED)

[TimU]

Gif shows the issue pretty clearly, only seems to happen when I adjust vertically (fine)

[TimU]

Noone else interested in seeing this fixed?

[Justin]

Hmm I can't duplicate it using the vertical (fine) mode, but can if I use the "move ignoring snap" modifier... can you post the project?

[noise_construct]

Confirmed.

Originally Posted by Justin

Hmm I can't duplicate it using the vertical (fine) mode, but can if I use the "move ignoring snap" modifier... can you post the project?

Just make a curve like his and use vertical fine, and it does exactly as in the gif. Can you post your project?

[TimU]

Another example of unpredictable automation behaviour, I can post a project file if needs be, but it's fairly easy to reproduce. It seems to happen when you have a lower segment surrounded by slopes, as shown in the gif

[TimU]

Here's a project showing the issue, though this one merges the previous point, rather than swapping the order of the end one and the next. Unfortunately I can't find the project that reproduced the original bug, but I know it'll come back to bite me at some point. I'll make sure I post it here when it pops up again