something stealing output 1 & 2
Greetings. I am on-site at the moment, working a festival. Just hooked up to record. In order to monitor the recording I am trying to route channel 1 to 8 to output 1 to 8. Simple, but not working. Something wants to use channel 1 and 2 as masters. I have deleted any outputs on the master fader, turned off master parent send on each channel, double checked to make sure each channel was routed to the correct output - it is. Channel 3 to 8 are fine. Channel 1 and 2 start to work as soon as I arm and setup the master send.
Under the routing tables, there is NOTHING being sent to the master bus.
Any help appreciated. I can record everything ok, but want to figure out what's going on.
Under options I turned off master/parent send....
At a loss of what else to do.
|