Clicking the Master track shows master FX if fx-follows-track selection set

[DaveS]

Works only in TCP. When the master track in the mixer is clicked the fx chain does not follow.

No big deal.

Cheers
Dave

[billybk1]

Could you kindly point me in the direction where this fx-follows track selection option is set. I can't seem to find it anywhere after looking through all the preferences screens, menus on right clicks, etc...... :(

Thanks,

Billy Buck

[CloudStreetsMusic]

Works only in TCP. When the master track in the mixer is clicked the fx chain does not follow.

No big deal.

Cheers
Dave

Hi Dave! Good to see ya here! ;)

[DaveS]

Hi Mark.

Good to bump into you too. :) 8)

Could you kindly point me in the direction where this fx-follows track selection option is set. I can't seem to find it anywhere after looking through all the preferences screens, menus on right clicks, etc...... :(

Thanks,

Billy Buck

Ahh, that was an earlier version. It's now Prefs/plugins/allow only one fx chain + open track fx on selection change + only if fx window is open.

Cheers
Dave

[billybk1]

Ahh, that was an earlier version. It's now Prefs/plugins/allow only one fx chain + open track fx on selection change + only if fx window is open.

Cheers
Dave

Ahh....gotcha

Thanks

[Dstruct]

Here (5.18 x64) it doesn't even work in the TCP. Selecting Master track doesn't switch FX Chain window to Master FX.