View Single Post
Old 06-04-2018, 05:45 AM   #133
cymbals
Human being with feelings
 
cymbals's Avatar
 
Join Date: Aug 2007
Posts: 138
Default

Quote:
Originally Posted by geraintluff View Post
Disabling individual bands could be fiddly - what would you think about a range control (or high/low dials) to determine which bands were active? I think it would be cleaner. Frequencies outside that range could be left alone or trimmed (highpass/lowpass) according to a setting.
That sounds great - whichever is easiest!

Hey, not sure what caused it, but I ran two instances of spectrum matcher on the master bus, for A/B'ing with one active, and when I re-opened the project there was a loud roar until I turned off the one active spectrum matcher. Never had that happened with just one instance, but was able to repeat the problem.
cymbals is offline   Reply With Quote