Not normal message. Just Reaper quit then says Windows will search for a solution.. or something I’ll have to make it happen again.
System is Win10 x64
Gigabyte z170x gaming7
i7 7700k
32gb ddr4 3200
Samsung 850 Pro
WD m.2
UA Apollo16MKII
Using Startech Thunderbolt adapter to Apollo.
I built and changed over to Apollo in the middle of 2 projects because my SSL converters died.
I ran those off an RME Digiface on my old machine. I already built this Daw only few weeks old had the RME in this and the SSL hooked up running. I choose this MB because of future Thunderbolt use.. but wasn’t planning to have to buy Apollo this soon money wise. But had to when SSL stopped working.
So I did a reformat and seemed fine then last nights session had a few weird things happen.. I knew I’d deal with something’s as I go.. and get it all tightened up.. but then crashes like this.. and a few times I’m doing something as simple as using SWS markerlist to highlight intro and end of tune getting ready to render and the UAD meter usage window was laying over top SWS markerlist.. I grab to drag it off and Reaper crashed then too.. at least twice when I tried it again. Don’t understand why it’s acting so unstable on new build when I would think it would be better then my last machine.
I also started it with resets configuration just to see what would happen if I render from there but before I even could bounce Reaper quit after I clicked some other stuff not sure.. I tried this reset after it seemed my normal one got stuck in a loop of open and crash before it went to my default session which is a blank start I’ve had forever..
|