Quote:
Originally Posted by Nip
Presets are probably made on some unity material levels for each purpose.
Look at GR meter and see if any compression is going on.
If ok input levels are probably ok, if no overs indicated.
Depending on material I look for 2-6 dB activity on compression peaks.
I often have to reduce gain on clips even, these hardware emulating stuff seem not to cope too well when hot. So knob is not always enough in my case.
Then activate output knob meters and see where you are.
|
That's about the range of compression I get. I'm comparing to MJUC, for which all the presets are serious smash.