Quote:
Originally Posted by BlessedOne72
The SSD - drive was installed first and Windows was installed to that drive first ; After that the 2 separate SATA - drives were added to the system . After that I cloned the new OS (SSD - Drive) to one of the SATA - drives with Macrium Reflect Free .
|
I'd try unplugging the two added drives and see if it will boot. Just pull their SATA cables with no power connected, and see if it will boot. If it does, then it is likely that one of the other drives is being connected to a SATA port that has higher boot priority than the one the boot drive is plugged into. Usually the SATA ports on the mobo will say SATA0, SATA1 and so on. Boot drive should normally be in SATA0 unless the BIOS has been instructed to boot some other port/drive first.