Quote:
Originally Posted by Geoff Waddington
You only need the power supply for the Fader motor - aka - if you want Reaper to be able to move it.
I wrote the original driver software for Sanewave/Presounus around 2006, my first control surface software gig
I seem to recall it was easy to brick/semi-brick these way back then -- have you tried various firmware versions ?
It should put out a steady stream as you move the fader -- bracketed by touch on/off messages -- maybe just a bad fader ? happens reasonably often -- probably the most common failure industry wide across all control surface brands
|
That's awesome!
No the fader is fine. It works completely fine with the faderport xt drivers from the forum here. So I guess if all else fails I'd go back to that. But I definitely wanted to try the the last touched parameter thing (sorry forgot what you called it
) as well as using some of the buttons as modifiers for csi.
There is a firmware update but its very hard to accomplish so I gave up there.