mixdown using hardware console & Reaper
Can anyone give me a heads up here as im kinda stuck
Im using an Allen & heath gsr-24 console & not sure how to best set up Reapers routing for mixdown & mastering
Also im not sure whether to route via Reapers Master/parent send OR the hardware outputs ive been told it's best to turn Master / parent off
for mixdown ive been routing via the console & back into a stereo ch in Reaper with OK results
The problem im finding is that im pegging meters in the analogue chain & anything i place on Reapers Master bus within the project effects the analogue meters in a bad way unless i turn down the mix to a very low level
My mixing levels are not over loud OR ridiculous
Im sure this is just a routing issue that im not getting to grips with
Anyone that can help me here would be much appreciated
Last edited by manley; 10-01-2014 at 11:25 AM.
|