[Gass n Klang]

Hey guys,
I found the following problem:

1) Create a track
2) Show panning automation (should be buggy with every other parameter, too)
3) Set two automation points: One at lets say exactly 5.1.00 with point shape "Square" and another automation point at exactly 5.1.00
4) If there is a playback running, stop it
5) Jump exactly to 5.1.00: the automation will not be read, just a short time after the automation point

In mixing audio this is not relevant at all, since the you won't recognize that problem (automation is read right after the point)

But I want to use reaper for as a live mixer and create markerpoints with different automation setups to recall by jumping through some markers. So I have to set all markers a little bit behind the automation points.

Would be really nice to have the automation read exactly at the point where it's written.

PS: I'm in the "read" automation mode