View Single Post
Old 08-16-2010, 01:17 AM   #93
JohnnyMcFly
Human being with feelings
 
JohnnyMcFly's Avatar
 
Join Date: Apr 2009
Posts: 1,343
Default

hmm..EQ you say?

What if?

Each IR Cab that you load could have an EQ profile attached to it? Even external IR files not shipped with Shred. So load a file called X and if there was a file called X Profile, it would load X profile into the Cab loader and eq your final output for you?


HAHA, been there done that already and waiting for the sequel, in this case Shred 2.0. All the infrastructure to attach and dynamically load external EQ profiles is already built into 1.5x. As a matter of fact, its identical to the modeled cabs except it does not contain the dynamics. The file formats are identical.

This is the NIR format, I am almost hesitant to call it a format because it is so simple...
0.4625
0.7625
0.75
0.004375
0.13375
0.5
0.039625
0.12875
0.5875
0.146375
0.08375
0.5875
0.29075
0.43625
1
Each number represents a percentage where the 1 is a knob thats on full, It goes like this..
Strip 1 Gain
Strip 1 Frequency
Strip 1 Q
Strip 2 Gain
Strip 2 Frequency
Strip 2 Q
Etc..
The final 1 on the end is the volume of the Cabinet

Simple...eh?

This came about because I wanted to try and blend the dynamics of the modeled cabs with the Static IR files to give them a little more life. That didn't work out, but what did was the EQ from the modeled cabs being blended with the IR cabs...So I left it as is almost complete. This is one of the first things I am going to do for Shred 2.0..If the profile does not exist then it ignores it...If it does, a switch appears that allows you to turn on the eq..

KM
__________________
http://www.acmebargig.com/

Last edited by JohnnyMcFly; 08-16-2010 at 04:39 AM.
JohnnyMcFly is offline   Reply With Quote