View Single Post
Old 01-26-2020, 03:30 AM   #6189
SebyMusic
Human being with feelings
 
Join Date: Apr 2018
Posts: 211
Default

Quote:
Originally Posted by MixMonkey View Post
Here you go. I've included both a .bcr file and a sysex file, so you've got a choice of how to load it. It will overwrite the current patch (so pick an unused one) The .bcr file has it as patch 1.

The naming convention is as follows:

Top row of Rotaries are RotaryG1-1 to RotaryG1-8, RotaryG2-1 to RotaryG2-8, RotaryG3-1 to RotaryG3-8 and RotaryG4-1 to RotaryG4-8 (the 4 groups) Their pushes are RotaryPushG1-1 etc.

The 16 buttons are UpperButton1 to UpperButton8 and LowerButton1 to LowerButton8.

The top row of plain rotaries are RotaryA1 to RotaryA8, the middle row is RotaryB1 to RotaryB8 and the lower row is RotaryC1 to RotaryC8.

The four buttons at the bottom on the LHS are UserButton1 to UserButton4. Phew

It's late here so I'm going to bed now but see if you can get the BCR2000 loaded ok and check that the messages being sent are correct. I'll be back tomorrow
Hi MixMonkey, thank you very much for all this.
I have 2 questions for you...


First Question:
Do you think you could provide the zon file also so I could study it a little and try to understand it better the way you use it?

Second Question:
Before, on the bcf2000. when no parameter was assign or not written at all in zon file, the lights on knobs were OFF.
Now, they are always on on first led.
Is there a way to show light on only assigned parameters?

tks
Seby

Last edited by SebyMusic; 01-26-2020 at 04:49 AM.
SebyMusic is offline   Reply With Quote