tpulse, you could verify that the knob sends the data the widget expects. I worked off the specs in the manual which were identical to the FP16, but there could be a mistake on my side.
Call up the action CSI edit mode, check the two in and out checkboxes on the right and start moving the knob, and change the .mst if necessary.
If all is well however, then it could be just a mistake in installation or configuration when setting up . Install the package again, more slowly.
I‘ve got an update coming that puts in VCA mode, adds pan width to the big knob and brings in more colour to the automation buttons for shift and alt combos.
|