Old 05-18-2017, 09:30 AM   #1
CharcoalBurner
Human being with feelings
 
Join Date: May 2017
Posts: 2
Default M-Audio Fast Track USB interface

I am evaluating Reaper presently and like it very much - quite intuitive but very comprehensive in sound editing features. It is running under WINE on Linux Mint18

I cannot pick up my M-Audio Fast Track USB interface. I think its to do with ASIO drivers - or lack of them. If I choose ASIO drivers under Devices it reports - no ASIO drivers found.

I have installed WINEasio, and qJackCtl. Also ASIO drivers from http://asio4all.com/ hoping that might run under WINE and be available to Reaper. But no success.

The interface is detected by my system and can be used with Audacity, so I know it's there somewhere.

Any guidance would be appreciated.....
CharcoalBurner is offline   Reply With Quote
Old 07-05-2017, 04:29 AM   #2
Aliumhunter
Human being with feelings
 
Join Date: Sep 2015
Posts: 8
Default

I hope this is not too late for you, but I have the same interface as you and also run it on Linux in WINE currently.

I recommend using Ubuntu Studio, as most of it's build is already tailored to audio recording (preinstalled low-latency kernel and such).

What you need is:
- Wine
- WineASIO
- JACK/qJackCtl

You don't need ASIO4All, actually. I always install it the following way:

1. Install Wine 64-bit, (qJackCtl as well, if you need)
2. Install Wineasio-amd64
3. Execute the commands "regsvr32 wineasio" and "wine64 regsvr32 wineasio" to register WineASIO
4. Configure JACK and start the Jack Server with qJackCtl.
5. Launch Reaper and select ASIO/WineASIO as the Device to use.

This should generally be your approach.

I also recomment having a look at the KXStudio guides, they can be very helpful. You may also want to use Cadence for convenience.

http://kxstudio.linuxaudio.org/Docum...sio_and_reaper

http://kxstudio.linuxaudio.org/Docum...Manual:latency
Aliumhunter is offline   Reply With Quote
Old 07-07-2017, 04:18 PM   #3
CharcoalBurner
Human being with feelings
 
Join Date: May 2017
Posts: 2
Default

Thanks so much for your reply. I had just about given up on being able to use Reaper, but am now trying to get it going again.

It all seemed to go ok, but I get the following error in Terminal;

steve@steve-Sony ~ $ regsvr32 wineasio wine64 regsvr32 wineasio
Failed to load DLL wineasio
CharcoalBurner is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -7. The time now is 12:55 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2017, vBulletin Solutions Inc.