Waves Q10 Prob
I inserted an instance of Waves Q10 (v5) onto a track and it pinned the meters to the ceiling (curiously only inside the Q10), and nothing would play when I pressed "play" ... What I didn't check for is if CPU usage went through the roof as well - but I don't think so - I was able to take it out of the chain right away. And after I removed it from the chain, everything was fine.
But, I did notice that there were some new drop-down menus for channel detection!!!!! Is this an effort to support routing from any channel to any plugin?
oh, and here are my specs if it helps:
Computer Model: Dell Inspiron 9300 Notebook
RAM: 1GB
CPU: Penium M 1.86Ghz
Hard Drive: 100GB 7200
Sound Device used at the time of crash: M-audio USB Pre
Reaper Version: v1.13
Crashed plug-in version: v5
Last edited by RedStone; 09-15-2006 at 07:58 AM.
|