'MCU_KLINKE"' indicates that you had a MCU Klinke Control Surface Extension used/installed. Did you already check if there are any Klinke specific Actions, settings, automations, etc. used in the project?
Can't remember right now if there's a more elegant way than editing the Reaper .RPP file itself (but make sure to do a backup copy first) - in case you don't want to install the MCU Klinke Extension (again).
But you might also try to simply save a copy of the project file under a new name and see if this works.
EDIT: If you want, maybe you can just attach the .RPP project file to a post? So I can take a closer look at this ...
Last edited by solger; 03-22-2018 at 04:43 AM.
|