NanoKontrol 1: After install, still says “not connected”!
Fixed…!!
Had to re-set it to 32bit.
Ugh…
=======================
Hi,
I have a Nanokontrol 1, and have downloaded and installed the drivers.
I checked Device Manager to make sure the driver was there…and it was (in sound, video and game controllers section) and of course, I’d run the “utility setup”, too.
But when I open the “Kontrol Editor”, it says my Nanokontrol isn’t connected…but it was, and the “scene light”, is lit up.
I’ve also enabled it in Reaper (in and out)…and Reaper acknowledged it…but I still can’t get the Editor to see it’s connected!
Anyone have any suggestions?
Looking forward to looking back on this problem!!
Peace,
K8ch
Last edited by K8ch; 07-13-2021 at 05:54 PM.
Reason: Fixed
|