Pan Tilt Roll
Hi.
I'm implementing a converter to take the "headpos2" data from a Samsung Gear VR and turn this into an OSC message.
I eventually want to be able to use this to drive the ATK RotateTiltTumble plugin.
I have four parameters from the GearVR:
qw,qx,qy,qz
AT present, i'm formatting these into an OSC message:
/ss/hp2 ffff 0.01f,0.02f,0.03f,0.04f
The message is happily landing in Reaper but I'm a bit stumped as to how to configure the OSC Pattern file to get it to send it's pan/tilt/roll data into the ATK plugin.
Can someone point me in the right direction?
I"m a bit new to OSC.
I also tried formatting this as four separate OSC messages but reaper got a bit flooded and stopped.
|