Data lost or delayed upon automation writing with OSC control
Hello,
I am trying to write automation for a VST using an OSC control surface.
Before writing, I can see that the connection is fine because the points are moving vertically on the envelopes.
However, when writing, it seems that data are lost or delayed. I have either a flat line or erratic movements which I think come from older movements I have made a few seconds before.
The connection is wired so no issue there. I have also checked that all the data reach the computer using an external OSC Monitor.
So what's wrong? Is there an OSC buffer somewhere which I could try to tweak? Should I reduce the dataflow from the controller?
Thank you in advance.
|