v5.79pre2 - February 23 2018

[LugNut]

Hi,
Man my graphics skils are non existant^^

I have more ...but it takes me forever..i hope this is obvious.
Thank you for responding Schwa.
Top is 5.60 repre1. bottom is 5.79rc2




Crap could have sworn i cropped the width?
Ill fix it in a bit...Sorry all. it is cropped...sorry.

[stamp]

Originally Posted by ferropop

In a large project: dragging a loop/sample to the correct place involves dragging it near the TCP for guidance, then horizontally following the track right to the intended location. Super clunky workflow, drags the screen Left if you go too far, etc.

There's Vertical guides for a reason - to ensure you're dropping something at the correct time location. Horizontal guides would ensure you're dropping it at the correct track, it's the exact same issue.
They could pop up only during a DRAG action, instead of being there permanently.

Dare I say that crosshairs on a grid system make some sense?

I think we should discuss this in the feature request section.

[deeb]

Regarding Divide view vertically previously discussed in abother pre topic:

Originally Posted by Dstruct

Can "Devide view vertically" get disabled if grid lines are disabled? I don't want to have this view in projects with no grid and ruler set to Minutes:Seconds. Looks weird and confusing.

Originally Posted by deeb

maybe there could be an option, something like:
- Divide view vertically and keep units by measures when no grid selected(default)
- Divide view vertically and change to seconds when no grid selected
- Divide view vertically and change to minutes when no grid selected
- Don't divide vertically when no grid selected

Originally Posted by EvilDragon

That is not the way it should be going... since the grid could be still set to bars/beats and not seconds... It should follow the ruler settings, rather than grid visibility.

and just to be sure it doesn't get lost i paste here:

seems this would be welcome has options or "mode":

- Divide view vertically by measures (has it is now)
- Divide view vertically Follows ruler settings
- Divide view vertically Follows grid settings

because following grid seems very useful too. Anyone against?

[vanhaze]

Originally Posted by ferropop

In a large project: dragging a loop/sample to the correct place involves dragging it near the TCP for guidance, then horizontally following the track right to the intended location. Super clunky workflow, drags the screen Left if you go too far, etc.

There's Vertical guides for a reason - to ensure you're dropping something at the correct time location. Horizontal guides would ensure you're dropping it at the correct track, it's the exact same issue.
They could pop up only during a DRAG action, instead of being there permanently.

Dare I say that crosshairs on a grid system make some sense?

Yes, my 2 cents also !
Meanwhile, i use this workflow:
https://forum.cockos.com/showthread....87#post1958987

[_Stevie_]

Thanks, huge fan of your videos!

[vanhaze]

Great to hear Stevie !