Hello
I changed my computer,
installed Reaper 5.62 (was using an older version before) , imported my configurations and now I have a problem.
I used to set a time selection , drag the automation line within it and Reaper would automatically create automation points at the beginning and ending of the time selection, so I could drag the line up and down without affecting it in areas outside the time selection.
Now it doesn't do that, the whole line moves up and down , inside and outside the selection
Not only that, even if I create automation points myself, when I move the cursor on the line between them, cursor changes to a horizontal arrow instead of a vertical one (I attached an image to show this) and changes tension , doesn't move up and down at all
Help me please