TLDR; how does a super switch work and how would one wire it up? I found the articles I googled to be not very descriptive
I recently bought this:
its amazing - and I wired it like this so far:
it has, by default:
3 pickups, the neck is a humbucker - I swapped it out for a blues pickup from guitar fetish - it has a switch for making it single coil. It was out of phase and fucked up but I fixed that.
I added a push pull pot to enable the neck pickup at all times so I can get the traditional neck/bridge pickup combo.
So I have the following sounds:
- bridge
- bridge middle
- middle
- middle neck
- neck
- single coil bridge
- single coil bridge/middle
- bridge/neck
- bridge/middle/neck
- single coil bridge/neck
- single coil bridge/middle/neck
I was thinking of making the volume pot a push pull and making the humbucker AND neck out of phase so I could add the following sounds:
- bridge and middle out phase
- middle and neck out of phase
- single coil bridge and middle out of phase
- single coil bridge and neck out of phase w/middle
- bridge and neck out of phase w/middle
But then I saw a super switch, and I wondered if I could accomplish this easier with that and maybe add an option to make other combinations like getting the neck and bridge out of phase